|
Analogue inputs:
- Throttle sensor.
- Airflow.
- Barometric (Atmospheric)/Boost pressure.
- Water (Coolant) temperature.
- Air temperature.
- Supply voltage.
- Mapping adjustment for fuel/ignition.
- Lambda sensor (narrow band).
- 2 x spare analogue inputs.
Digital inputs:
- Crank sensor input (magnetic or digital type set in hardware by RTD depending on required application).
- Cam sensor input (magnetic or digital type set in hardware by RTD depending on required application).
- 3 x ELS inputs (linked) (+12V to activate).
- Ignition switch input for mail relay (+12V to activate).
- Road speed input (digital type signal).
- 3 x spare digital inputs.
Outputs:
- 4 x injector outputs:- capable of driving 2.5ohm injectors directly for sequential injection.
- 4 x ignition trigger signals:- driving individual ignition amplifiers for sequential ignition.
- 6 x valve outputs.
- 1 x tacho output.
- 1 x shift-light output.
- 1 x TTL output.
- Mail relay +12V output.
Other details:
- ECU program stored in removable permanent EPROM memory. ECU map data stored in permanent EEPROM memory but changes can be made to maps via pc.
- At least one RS-232 compatible serial port & one parallel port are required for PC-ECU communications.
- Internal data logging RAM for recording last quarter hour of engine data (at 10Hz). Data logging is automatically activated when engine revs exceed user-defined point (1000rpm minimum). Logging is paused when revs fall below switching point. Data is downloaded and stored on hard disk in CSV text format for viewing on a third party data analysis package.
- Channels recorded are Engine speed, Throttle, Air flow, Pressure, Water, Air, Lambda, Supply volts, Spare input, Fuel injected value, Ignition advance, Cam position, logging start/stop marker and error flags for Cam sensor, Throttle, Air flow, Pressure, Water, Air, Lambda and Supply voltage.
- EMSPC V9.x ECU mapping software will operate under MS-DOS, Win3x, Win9x or ME operating systems. A third party driver (DIRECTIO) is required to enable use with Windows NT, 2000 or XP. New windows based mapping software is currently under development.
|
